Depo headlight with angel eye...help!!

[avusbluem98]

Ok i ordered a set of plug n play headlights with angel eyes, i got the passenger side in and working, but the drivers side...i have the one gray spliced into the gray/purple wire of the turn signal, and the plug n play harness hooked up, the low and high beam power supplies hooked up, but the rings do not light up, the driving beam does not work....just the bright comes on. ive double checked everything and as far as i can see, everything is hooked up right.....anyone else had this issue or suggestions???

thanks in advance.

[6speed ti]

Originally Posted by avusbluem98

Ok i ordered a set of plug n play headlights with angel eyes, i got the passenger side in and working, but the drivers side...i have the one gray spliced into the gray/purple wire of the turn signal, and the plug n play harness hooked up, the low and high beam power supplies hooked up, but the rings do not light up, the driving beam does not work....just the bright comes on. ive double checked everything and as far as i can see, everything is hooked up right.....anyone else had this issue or suggestions???

thanks in advance.

Swap it over to the other side and hang the light unit and hook up the wires. Swap HID ballast as well. isolate the light assembly and Ballast. This should answer your problem.

[Mr. Crow]

Originally Posted by avusbluem98

Ok i ordered a set of plug n play headlights with angel eyes, i got the passenger side in and working, but the drivers side...i have the one gray spliced into the gray/purple wire of the turn signal, and the plug n play harness hooked up, the low and high beam power supplies hooked up, but the rings do not light up, the driving beam does not work....just the bright comes on. ive double checked everything and as far as i can see, everything is hooked up right.....anyone else had this issue or suggestions???

thanks in advance.

Double check all of your connections, the plug n play wire for the AE may have popped out of the harness. or they are connected to the wrong pin all together.

Also, what method did you use to splice in to the parking lamps? I used Ttaps, but soldering is said to be best. (bad connection maybe)

If that fails, maybe you blew a fuse. Use 10a or 15a.

Good luck.

[slan2839]

Call me bout almost the same issue. Its weird need to ask a few ?'s. 828-707-3975. Thanks.

[Shellback]

where did you buy them?

[slan2839]

My problem is my high beam (passenger side) fuse blows everytime I turn them on? All the other lights are working right (minus passenger high beam)? But the high beam will work if I unplug the passenger side low-beam? Just not both at the same time, that blows the fuse? Tryed to use a 10a and 15a fuse rather them the 7.5a? Still blows? HeLP! Thanks...

[Mr. Crow]

Originally Posted by slan2839

My problem is my high beam (passenger side) fuse blows everytime I turn them on? All the other lights are working right (minus passenger high beam)? But the high beam will work if I unplug the passenger side low-beam? Just not both at the same time, that blows the fuse? Tryed to use a 10a and 15a fuse rather them the 7.5a? Still blows? HeLP! Thanks...

https://www.ddmtuning.com/content/te...6angeleyes.pdf