Pulled the door panel. Sliders are still good, but the front regulator ball popped out of the slider with the spring clip laying in the bottom of the door skin. The rear slider is still in place. Put the front slider back in place and lowered the glass. Popped out the front regulator ball and it is way too far from the ball towards the inside of the car about an inch away. Got a channel lock plier and straighten the regulator so it lines up with the channel where the slider sits. Put the regulator ball back in the slider, then the clip, and tested the window up and down a couple of times. I will leave the door panel out for a few days to make sure the window does not fall again. Thanks to Cooljess' write up. __________________ 1996 Ti 280k miles and still going.... 1993 964 - holding on to this one 2001 Burban, 240k miles 2018 Suburban Z71 |