318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Knowledge Base

Notices

Knowledge Base How to articles and things explained.

.
» Recent Threads
Choose your favorite...
12-07-2017 07:05 PM
Last post by Sphinxe
Today 05:06 AM
7 Comments, 698 Views
M42/M44 EXHAUST
Yesterday 05:00 PM
Last post by BRADESTAR
Today 02:10 AM
3 Comments, 150 Views
97 318ti DASC
11-29-2017 11:12 PM
Last post by cmoore
Yesterday 11:53 PM
4 Comments, 789 Views
Question: ti m52 swap...
12-08-2017 03:49 AM
Last post by anassa
Yesterday 07:18 PM
5 Comments, 633 Views
Gas tank vacuum pressure...
Yesterday 04:18 PM
Last post by amiller07
Yesterday 04:18 PM
0 Comments, 133 Views
WTB: My dream car
11-01-2017 06:00 AM
Last post by manydubs
Yesterday 01:14 PM
2 Comments, 597 Views
WTB Mtech Door Card
11-14-2017 12:20 AM
Last post by manydubs
Yesterday 12:58 PM
3 Comments, 722 Views
Rear window rubber
12-09-2017 09:01 PM
Last post by DGWGuitars
12-11-2017 09:50 PM
6 Comments, 518 Views
UK roll call
09-19-2005 10:40 PM
Last post by MAZI
12-11-2017 09:11 PM
361 Comments, 84,215 Views
FS: 1995 BMW 318ti Only...
11-28-2017 06:16 PM
Last post by manydubs
12-11-2017 08:10 PM
3 Comments, 622 Views
Comment Share/Bookmark
 
Tutorial Tools Display Modes
Old 10-18-2009, 02:27 AM  
MacUser
Senior Member
 
Join Date: Oct 2009
Location: VIRGINIA
Posts: 324
iTrader: (0)
Default HOW TO: Replace Hood Cowl


See the black plastic cap at the end of the wiper arm? To avoid unsightly marring, carefully pry it off. You'll need to do this on both the driver's side...

Last edited by MacUser; 10-18-2009 at 02:32 AM. Reason: optimization of the order of the photos
MacUser is offline   Reply With Quote
  #15  
By MacUser on 03-23-2010, 06:19 PM
Default

Now that you mention it, I'm not sure whether new ones came with the cowl pieces. If it did come with new screw caps, that would explain the color match.
Reply With Quote
  #16  
By roadrash on 03-23-2010, 06:38 PM
Default

Gotcha... I'll just figure it out when the order comes in, then report back here for future reference. :-)
Reply With Quote
  #17  
By roadrash on 04-05-2010, 10:08 PM
Default A few notes

I just did this and wanted to add a few notes:
  • The plastic grating covering the air plenum should be left on as long as possible. This will prevent nuts/washers/etc. from the wiper arms from falling into the vent system. Yes, I did.
  • I could have reused all of the clips, but went ahead and installed the new ones since I'd already purchased them. However, there was one weird square-shaped pin that I reused. Maybe that was unique to my car, I dunno. If you see it you'll know what I mean, if you don't see it, it's not an issue for you.
  • When you install the new cowl parts, be sure to check the outside edges and make sure that the vertical rubber window weatherstripping is ON TOP OF the cowl parts.
  • I also reused the round plastic screw-on caps on the passenger side. The color difference wasn't glaring, but I'll check it later just to be sure. I might add some Forever Black if it's noticeable.
  • Total time was about 1:30, but that includes installing cabin air filters and figuring out a way to make the e-bay filters work (and changing clothes once I realized that I was going to get dirtier than planned due to the unforeseen air filter installation). To do just the cowling shouldn't take more than about 30 minutes.
Reply With Quote
  #18  
By woh on 06-30-2010, 01:13 AM
Default

thanks for the write up and comments by others.

Easy yes, but the write up makes it easier yet and quicker.
Reply With Quote
  #19  
By 47driver on 01-06-2011, 05:15 AM
Default

Just did this. Thanks for the write up.
Reply With Quote
  #20  
By e24l6 on 02-06-2011, 08:07 PM
Default

need to do this when the snow melts...good writeup!
Reply With Quote
  #21  
By FLJayson318 on 08-11-2011, 10:37 PM
Default

Hey guys, home for summer doing some fixing up.
does anyone know which one it is on this page? http://www.trademotion.com/partlocat...&siteid=214672 . btw i have a 95(i just dont know why id select 4 door)
thanks in advance
Reply With Quote
  #22  
By Ulysses on 07-29-2016, 09:55 PM
Default

Thanks this is on the "to do" list as the current cowels are totally shot and falling apart.
Reply With Quote
Comment

Bookmarks

Tags
cowl , cowling


Currently Active Users Viewing This Tutorial: 1 (0 members and 1 guests)
 
Tutorial Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Similar Threads
Tutorial Tutorial Starter Category Comments Last Post
part number wiper cowl chriswashburn18 Exterior 2 02-05-2009 05:12 AM
Hood or hood parts Flametail US and North America 3 11-02-2008 04:36 AM
4 sale - hood bra, filters, hood strut, fog light covers nontien US and North America 3 07-23-2008 03:53 PM
318ti hood and 325i hood the same? Pejacob97 Exterior 16 04-16-2007 10:19 PM
installing a new cowl ? cobaltbloo Exterior 1 11-21-2006 02:18 AM


All times are GMT +1. The time now is 12:21 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2017, 318ti.org

Tutorial powered by GARS 2.1.8m ©2005-2006
© vBadvanced CMPS v3.2.2
[page compression: 78.22 k/99.52 k (21.40%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.