» Site Navigation | | » Recent Threads | 1999 M3 Swap 09-07-2023 10:10 PM 05-02-2024 08:18 PM 6 Replies, 331,011 Views | | | | | | 03-18-2008, 10:58 AM | #1 | Member Join Date: Jan 2008 Location: lancashire Posts: 48 | Problem with starter..Wont crank? iv just done an engine conversion to my Ti its 96 and the engine is a 96 328 motor..(which has ewsII) basically my car wont crank , not even click the solenoid.. i jumped the two wires (1 and 3) going to the ews unit so that there should be a direct current from the ignition to the starter.. the starter is fine because when i short it out with a screwdrive and a bit of wire it engages so theres a problem with the starting circuit? or similar. could be the ews im not sure but i eliminated that part for the starter i think or is there a signal required from the ecu aswell as the ignition feed? what is the small green/black wire for on the starter? i know the black/yellow is from ignition.. does anyone know what it could be? | | | 03-18-2008, 11:15 AM | #2 | Member Join Date: Jan 2008 Location: lancashire Posts: 48 | could my relay be gone? which one is for the starter? i heard you can test the starter through the diagnostic port on pin 11 but theres nothing there on pin 11?... would twisting the two wires from the ews unit be enough to bypass it just for the starter side ? i know ews stops the injection and fuel etc.. so they obviously wouldnt be affeted ..anyone ? im pretty confused iv tried lots of diff things.. also the buzzy thing coming from the manifold stays on even when ingnition is off , it comes on when i short the starter | | | 03-18-2008, 12:39 PM | #3 | Member Join Date: Jan 2008 Location: lancashire Posts: 48 | right i have just confirmed my ews works, i shorted the black/green wire to the black terminal and the starter clicked but didnt turn over , i tested this with my 318ti starter and it did the same.. so when i turn the key the starter clicks... but why the hell does it not click when i remove that shorted wire? whats the green/black wire do? | | | 03-18-2008, 11:58 PM | #4 | Senior Member Join Date: Nov 2006 Location: Land of the Vikings Posts: 2,700 | what did u swap over stuwey? Motor + ecu+ antenna+ key otherwise it wont work mate __________________ Vin Number decode and Retrofit Pdfs Available Free ! Just PM | | | 03-19-2008, 11:19 AM | #5 | Member Join Date: Jan 2008 Location: lancashire Posts: 48 | motor, loom, ecu, ews system (box and chip etc..), plus all ancillaries for it to run.. | | | 03-19-2008, 11:28 AM | #6 | Member Join Date: Jan 2008 Location: lancashire Posts: 48 | what do you mean by antenna? | | | 03-19-2008, 08:47 PM | #7 | Senior Member Join Date: Nov 2006 Location: Land of the Vikings Posts: 2,700 | the ring around the key hole . but it should be the same with any ring. __________________ Vin Number decode and Retrofit Pdfs Available Free ! Just PM | | | | Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | | Posting Rules | You may not post new threads You may not post replies You may not post attachments You may not edit your posts HTML code is Off | | | |
All times are GMT +1. The time now is 04:16 PM.