1995 318TI KKNOCK SENSOR WIRES

[TRICKYDICKYD]

Can anyone tell me what connector goes to one plug, i disconnected the wires from the black box inbetween the upper and lower inlet manifold so in could replace the starter motor (never again!) only to find both knock sensors have the same plug and socket so. i have tried the haynes and there's no wiring diagram for the sensors, but it does say to make sure they are plugged into the correct socket/plug
I have my car in bits and it's pouring down of rain, i need to get it back together asap

Thanks

Richard

[Xenocide]

Look in the electrical diagram and check the colors for each plug, pull back the boot and match them up. You only need to post once.

[TRICKYDICKYD]

Got it all back together, just guessed 50/50 chance of getting it right. Just been out on a quick 15mile drive, seems to be running fine. I'll get carsoft on to it tomorrow and check the fault memory.

Sorry about posting twice, didn't know what fourm was better, engine or electrical.I was desperate.

Thanks for the advice.
Richard