Noob with a drive belt tensioner question Just inherited a 1996 318ti California (M44 engine) with a number of problems. One is a serious oil leak from the oil filter mount, which makes it hard to track down the other oil leaks. I got the gaskets, o-rings and bush (?) to fix the leak, but when I went to take the belt off I could not loosen the tensioner. All the info I could find on-line says to use a 16 mm wrench to loosen the tension & remove the belt. Problem is, I can't find any hex to put the wrench on. There is a Torx or Hex in the center of the pulley (axle), can't see it well enough to tell which but none of my Allen or Torx bits fit it anyway. What am I missing? |