speed sensor wire questin for aftermarket navigation unit 1999 318ti installed a jvc kd-nx5000, there is a speed sensor wire that needs to be connected for the navigation to calibrate and work, untill then no navigation funuctions, my question is does anyone know where i can tap into for this speed sensor? i read elsewhere this: The vehicle speed signal should be any of the .35 or .5 mm^2 SW/WS (black with a white stripe) wires going to the: instrument cluster cruise control wiper module HVAC board computer / multifunction clock radio or comb terminal block on the left wall of the driver footwell. my question to that woudl be, is black with two white stripes the same thing? UPDATE: NEVER MIND, found on another forum that pin #10 in the radio harness has the black wire with white stripe and i used that. |