318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Knowledge Base


Knowledge Base How to articles and things explained.

» Recent Threads
xxxJohnBoyxxx is back
Yesterday 10:38 PM
Last post by Estii
Today 02:20 AM
3 Comments, 70 Views
Miscellaneous Parts for...
02-13-2018 10:56 PM
Last post by Earl
Today 01:28 AM
18 Comments, 1,795 Views
1997 BMW 318ti fuel pump...
Yesterday 12:00 PM
Last post by Gear2Fear
Yesterday 12:00 PM
0 Comments, 119 Views
WTB Auto 318ti
02-14-2018 05:00 AM
Last post by joereeumd
Yesterday 04:34 AM
5 Comments, 757 Views
Blower Motor and Resistor
02-22-2018 03:17 AM
Last post by Johjamkep
02-24-2018 09:27 PM
2 Comments, 365 Views
WTB: sand grey cloth...
02-20-2018 03:29 AM
Last post by e30/e36_kid89
02-24-2018 04:44 AM
1 Comments, 376 Views
Half Shaft Boot Info
02-24-2018 12:51 AM
Last post by sirius815
02-24-2018 12:51 AM
0 Comments, 151 Views
Possible EWS Issue?
02-23-2018 10:59 PM
Last post by reeve509
02-23-2018 10:59 PM
0 Comments, 120 Views
FS: Racing Dynamics 16 x...
01-03-2018 03:04 PM
Last post by manydubs
02-22-2018 02:11 PM
7 Comments, 1,566 Views
How to program a new key...
09-08-2008 05:53 AM
Last post by ///msport
02-22-2018 01:04 PM
61 Comments, 38,048 Views
Comment Share/Bookmark
Tutorial Tools Display Modes
Old 04-18-2011, 09:22 PM  
weloveiggy's Avatar
Join Date: Sep 2007
Location: Rock Hill, SC
Posts: 75
iTrader: (0)
Default Clean A/C compressor clutch plate & pulley and remove spacers.

Based on my symptoms, I decided to give this a try.
***UPDATED 7/22/11*** - Added info on removing spacers.
My symptoms were...
1) A/C worked sporatically, then not at all.
2) When it did work, it was ice cold. (I didn't suspect low freon)
3) With the connector...

Last edited by weloveiggy; 07-22-2011 at 07:14 PM.
weloveiggy is offline   Reply With Quote
By bluoval6 on 05-09-2017, 03:21 PM

Yes, low charge will cause short cycling. What that means is the compressor is cycling out too soon and doesn't run long enough to work properly. There is a pressure switch on the low pressure side of the system that will cut power to the compressor coil at a certain setpoint, usually around 20PSI. There are 2 reasons for this-one is to protect the compressor from running when there is not enough refrigerant/oil being pulled into it, the other is to keep the evaporator from freezing up. If there has been nothing done to the system in 20 years, it's very likely low. No a/c system keeps its charge forever. Eventually, seals and o-rings get old and start to leak. If it's a small leak, you may be able to get a shop to top it off, or go to a parts store and get a can of 134a and a low side hookup. This would allow you to top it off yourself. Hope this helps.

Reply With Quote
By Ivan on 05-10-2017, 11:04 PM

Yeah, that makes sense, thanks for explanation. I think you helped me a lot. I will update you on this case when I resolve it if you are interested.
And yeah, does it make any difference if i change out refridgerant or add how much is missing because i heard some shops are changing refridgerant?

Have a good day!
Last edited by Ivan; 05-10-2017 at 11:09 PM..
Reply With Quote
By Ivan on 05-22-2017, 01:54 PM

Update on my case
Diagnostics showed i had 400 grams of 134a instead of 850, and 12ml of oil. System is now filled with 850 grams of refrigerant and 10ml of oil (dont know why if there was 12 but macanic said its okay, that most cars are okay with 10.) Cooling is now significantly more efficient at higher fan power settings, but still my compressor is disengaging while driving. I find that annoying and im worried about clutch wear. Since its working continously on idle and lets say 1500 rpm my guess is that compressor is ,,overpowered" for that system because all liquid refrigerant may not be able to evaporate before exting evaporator if compressor is running at higher rpm. It bothers me quite a lot because im driving on straight road for half an hour at exactly 50mph, engine about 2250 rpm in fifth gear and my compressor is disengaging every 25 sec, wich has no sense to me at all since that is relatively low rpm. It just gets worse when driving on highway...
Reply With Quote


Currently Active Users Viewing This Tutorial: 1 (0 members and 1 guests)
Tutorial Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Similar Threads
Tutorial Tutorial Starter Category Comments Last Post
AC compressor clutch fix?? weloveiggy HVAC 9 06-15-2011 10:29 PM
VA BRAND NEW E36 AC Compressor w/clutch Denso LEXUSGS43O US and North America 1 04-24-2011 11:48 PM
E36 318 Pressure Plate. Defective, But Clean & New CirrusSR22 US and North America 0 09-11-2009 12:08 AM
WTB: A/C COMPRESSOR OR MAG. CLUTCH. tasimm US and North America 4 10-25-2008 09:41 PM
FS: Clutch Plate drkblu318ti US and North America 3 09-02-2007 04:16 AM

All times are GMT +1. The time now is 04:46 AM.

Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2018, 318ti.org

Tutorial powered by GARS 2.1.8m ©2005-2006
© vBadvanced CMPS v3.2.2
[page compression: 72.21 k/86.49 k (16.51%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.