I went to the junk yard today and picked up a front lip from a mkIII jeta for $10, then stuck it on the ti. A few others from these forums have done this same mod, but when I was searching for it I never found a how-to so I figured I would add one.
Clean it up. I used the bath tub, sponge, and some paper towels.
remove bumper- there are 4 bolts under the molding on the front bumper and 1 bolt on each side of the inner fender well.
mock it up- it was almost a perfect fit.. just a little to trim on each side.
Securly fasten the lip to the bumper. I drilled holes and bolted it on with 4 heavy duty bolts, then put about 10 zip ties on for extra security. This wont be comming off if I scrape, unless my whole bumper comes off...
Trim the sides-
AFTER:
/D