Project Ti.

[Chigga]

Originally Posted by BimmerBum

That is pretty standard. If you buy a complete engine from the dealer it does not even come with an intake manifold. Sellers generally charge extra for accessories if they have them. This is part of the reason that buying a wreck is such a good way to go if you are considering a swap... you will have everything you need.

The worst part was that I asked for everything I needed to swap into the Ti from the start up, since its a swap I wanted everything at one go, I bought an engine before from a yard before and it was a long block, which was fine as it was a replacement swap, but this time was just a bad experience for me, there was no communication and I sat in the dark wondering what is happening or if at all after the engine was dropped off.

[black98]

What kind of springs did you get, I like how your car is sitting

[Chigga]

Originally Posted by black98

What kind of springs did you get, I like how your car is sitting

BC Coils for the Z3.

[black98]

Is it all the way around or what you using in the rear

Sent from my PC36100 using Tapatalk 2

[Chigga]

Originally Posted by black98

Is it all the way around or what you using in the rear

Sent from my PC36100 using Tapatalk 2

All around, they don't have the Ti on listing, but just order a Z3 and you can spec the spring rates, I went with 8k all around, might go with 8k/10k later on.

Right now I have a question/problem, I used E36 M3 exhaust from mid section all the way back, shorten it and got it fitted, but I had to trim the left side of the diffuser to let the dual tips fit and frankly, I don't like it, you can't tell from 10 ft away but you can see the trimming up close, will 323ti diffuser clear the tips? and does anyone sell them in North America?

[Chigga]

Here it is all tidied up, E36 M3 mid-rear section, euro tails, M3 front bumper, BUT now the flexi mount is gone as there's horrible 2nd gear shudder.







Still working on the RGR

[Chigga]

Here it is doing some track action with the racing dynamic's temp finish and 235/40/17 Toyo RA1





car performed well but ABS wasn't engaging.

[Chigga]

Here is some video from the track event:

[MTRD3]

Hey Sam,

Car is looking great, Rudy sent me the video from Mosport, he said the car was a blast to drive (My answer was I told you so ). Did you ever figure out your diffusor issue? I'll PM you on Max, see if I can help out.