Q: How many 318ti.org'ers does it take to screw in a fog light bulb?
A: At least 3, because here i am
I think I can connect the dots since I just did this last weekend mostly in the dark, which is not a bad time because the flashlight works better (seriously):
1. Look at the edge of the air intake next to the fog light, find the upper hole that angles toward the fog light.
2. take a medium length flat tip screw driver and insert into the hole about 1"-2" (3-5cm) keeping the blade roughly vertical
3. Find that V-shaped pocket on Dave's picture* and push gently but firmly
4. Fog light will magically pivot open revealing a tiny cave with Leprechauns and gremlins, take their gold but do not let them escape.
5. Backside of fog housing will have a plug on the wire, twist to remove.
6. once open release the wire spring clip and pull out wire+bulb
7. gently wiggle the old bulb off blade connector/socket
8. IMPORTANT: when installing new bulb do not touch with fingers, your skin oil shortens their life (or so I've heard). I keep the plastic bag on to install them.
9. Reassemble, repeat other side.
Hardest part is finding the release lever!
* Dave's photograph is upside down and shows the backside of the part but not sure how that translates to New Zealand because you're upside down from us anyways.
![Wink](http://www.318ti.org/forum/images/smilies/wink.gif)
In any case the photo is of your left fog light carrier.
Hope this helps!