Need a confirmation. 2.8Z3 coilovers on the TI Searched, didn't find a definite answer. I found one post saying they will work, but the rear sits too low. Then another where Jim said he ran the Z3 setup but swapped in the whole rear subframe as well. One other guy chimed in and said he ran the Z3 setup, but didn't comment much on the spring rates. I know Tony has run the Mz3 stuff, I'm assuming that has to do with just the spring rates. I found a Z3 coilover set for $300, and I'm thinking of grabbing it if it's a decent brand, just shot the guy a mail. If the spring rates are less than ideal then screw it, I like my H&R Races, but the ability to lift it up for the winter/drop it a little lower for the summer appeals to me. Also, it'd let me lift the rear enough to run a proper tire on my 9.5" Millies __________________ 1995 318TI base. 95 2.5L from 325IS. S50 cams+pistons, e36 M3 front brakes. H&R race springs F+R. Turner Motorsport front sway bars, M3 control arms. M Roadster rear sway bar. Racing Dynamics strut brace. e36 325i 5spd. 3.25lsd from e28 535is. M Roadster short shifter. Conforti chip. |