Completed:- Title Registered
- Flex Disc replaced
- Cleaned heat shields
- Exhaust gasket and nuts addressed
- Tranny mounts replaced
- Short weighted shift knob installed
- Figured out how to get into the Subwoofer for inspection. Subwoofer looks and sounds clear. The rear drivers side mid is blown as is the passenger lower mid/low in the kick panel. Additionally, the drivers door speakers are not working. Repaired the cracks in the Subwoofer lid from underneath.
- Adjusted trunk lock
The car was running smooth and sounding healthy after addressing both the Flex Disc and the exhaust issue. Then, after a little spirited driving, a terrible, constant misfire.
My BT reader indicated that the #4 plug started misfiring. Upon inspection, the boot was torn off and #4 plug was shorting on the block. I ordered new Magnecor wires and in the meantime, I'll see if I have a spare in storage this weekend to temp replace while I wait for the new wires.
I also noticed a familiar rattle behind the drivers seat. I suspect the Drivers side RSM is blown. I'll replace them both and install the reinforcement plates.
No worries, i'm expecting to find stuff and just address them.
I should prolly post this in a Z3 site, but since much of the work to be done is just about identical as to what you need to do to a TI for reference, I figure I'd update here, unless anyone objects.
Cheers!
