318ti.org forum - View Single Post

Trusted-1 · 02-07-2010, 05:35 PM

I am looking for the curved rubber boot to connect the ASC to the cone filter for the DASC kit I am trying to install.

There is a nice looking part in the install shown in the Notebook DASC Custom install article by Gerry Doiron and Hugo Villanueva

http://www.318ti.org/notebook/dasc/installed.htm

but I do not know where this came from.

The kit I bought was used and was still on the car but it was missing the DA aluminum intake elbow from the kit.

I need to leave the ASC in place since the ti is driven daily by my Wife so I would prefer to leave it in place...

Thanks in advance for help locating this part.

02-07-2010, 05:35 PM	#1
Trusted-1 Senior Member Join Date: Mar 2008 Location: San Diego Posts: 179 iTrader: (1) Photo Gallery	DASC Install Help!! I am looking for the curved rubber boot to connect the ASC to the cone filter for the DASC kit I am trying to install. There is a nice looking part in the install shown in the Notebook DASC Custom install article by Gerry Doiron and Hugo Villanueva http://www.318ti.org/notebook/dasc/installed.htm but I do not know where this came from. The kit I bought was used and was still on the car but it was missing the DA aluminum intake elbow from the kit. I need to leave the ASC in place since the ti is driven daily by my Wife so I would prefer to leave it in place... Thanks in advance for help locating this part. Last edited by Trusted-1; 02-07-2010 at 07:50 PM.