Quote:
Originally Posted by xxxJohnBoyxxx  I install my simulator in the cabin since they are not weather resistant.
Wires need to be long enogh to reach both O2 sensor signal wires and power wires need to be long enough to reach the air pump plug so it is powered by the DME calling for air pump at the plug. I do about 7 feet of wire on each connection and cut off what I don't need.
You can also tap directly into the DME wiring harness for a shorter wire solution however it is not fun tearing apart the wiring harness and you need the DME diagram pinout for your cars year & model to ensure you are tapping the correct wires.
John Smith |
Well I ordered the batchpcb board nOt realizing it takes about a month to get it....... Huge let down...
Anyway, what gauge wire would you recommend for this thing. I want it to be functional but not have too thin/thick wires running all in the engine bay. I was thinking of maybe putting the box under one of the cabin filter housings since I wouldn't know where to begin or where to put it if I were to route it to the inside of the car.