View Single Post
Old 09-30-2008, 05:33 AM   #3
CirrusSR22
Senior Member
 
Join Date: Nov 2004
Location: Minneapolis
Posts: 1,587
iTrader: (3)
Default

• Remove and replace the passeneger’s side engine mount. Gently lower the engine back down onto the new engine mount, making sure the mount is properly lined up. There is a locating pin & hole to line up. Start threading the nuts back onto place, but don’t tighten them. Make sure the heat shield (passenger side only) is back into pace.

Locating pin (passenger side).


Passenger side in place.


• Now that the engine is resting on the new mounts, double check to make sure the engine is properly lined up on the mounts. Tighten and torque the mount nuts. 33 ft-lbs. Use new nuts or Loctite or both.



• Bolt everything else back into place. Don't forget the intake boot if you removed it.
CirrusSR22 is offline   Reply With Quote