Severian, you can burp the radiator by loosening the plastic screw at the top or the radiator next to the fill cap, start the engine and let run. You will loose some coolant so you might want to put something under your car. Let the coolant flow from the hole where the screw is until you only have coolant and no air escaping, then tighten up the screw. easy. My heater was blowing cold this fall, I replaced the bowden cable from the temp dial to the heater box and it fixed mine. Check to see how far the cable is opening the flap at the box, it should open all the way, mine wasn't. |