I was going to do a write-up on this, but never got time to do it.
You ned to locate where the holes will be by duct-taping the lip to the car (if you remove the entire bumper cover, it's MUCH easier to do). Then drill small round holes, no wider than the flats of the square (maybe smaller), then make them square with a file, then oval them (if memory serves- it's been a while).
Basically, you make a 'socket' and the plastic clips push in, and rotate 90 degrees to lock into the bumper cover. Then apply the 'lip' and screw it down.
It's a very time consuming and tedious process. I had some photos posted for a while, but they are down now. Not sure if I still have them or not... |