Quote:
Originally Posted by BlackBMWs ??? Odd. You slammed on your brakes then after it seemed to into limp mode? I think you have a 20 pin port in the engine compartment. 1. Is it on tight? 2. If so, try swapping another cap on as they can fail. That was a cause of my ODBII port not reading properly. Got a replacement cap, viola! Not sure if this your issue, but it was mine. Good luck. If I can help w parts, I will. Cheers! [emoji41] Sent from my iPhone using Tapatalk |
Yup, it was cruising just fine before that. I have checked the 20 pin cap, and it is as tight as it can go. I can try replacing it to see if it helps though.