Hey guys when I put my subs in a while ago, I found a hole in the firewall behind the battery case. Its a small pain but if you remove your battery and take out the battery tray there is a rubber hole for running wires. I used a standard screwdriver with the sub wire taped to the end of it running parellel. Shouldn't be too much of a problem from there. Then I ran the wires under the passenger side carpet and under the trim all the way to the back. It only takes a second to pull up the back seat and run them under it. Not sure if you guys are using the same entry point in the firewall, but the one I used I would really recommend. It's worth the time to take out the battery and the case and you can't miss the hole after you do so. Toughest part for me was getting the trim to stay back on with the wires under it, but it all worked out and no wires are visable at all. Good luck guys and remember keep it lookin clean!
