View Single Post
Old 01-13-2013, 09:36 PM   #79
patpsc
Junior Member
 
Join Date: Jan 2013
Location: Florida
Posts: 1
iTrader: (0)
Default

Same here. I have one stripped hole at the top inside corner near the half-moon. I used another bolt with the same length with the original factory one but it's threaded all the way to the hex head (there is no stop washer at the thread end). The bolt is tightened but I didn't torq to specs because I'm afraid it will spin again forever. Is it ok to leave like that or do I have to re-thread the hole? I dove the car around for 1/2 hour and there is no leak on that bolt. What's your best solution to this?
patpsc is offline   Reply With Quote