View Single Post
Old 01-29-2021, 03:39 AM   #42
StoneWheelRacing
Member
 
StoneWheelRacing's Avatar
 
Join Date: Dec 2020
Location: Upstate NY USA
Posts: 38
iTrader: (0)
Default

Looking for a way around the exorbitant prices of used Z3M LCAs.

I know its a bit off topic but I'm wondering if Z3M rear bearings and hub will mount into non M Ti rear lower control arms? I suspect not. To go way out on a limb can the spindle castings be bored out to hold those bearings??

Seems to me if either of those is possible you can then use the vented rotors without dropping the big money on LCAs.

Is the M outer CV joint splined shaft a larger diameter also?
StoneWheelRacing is offline   Reply With Quote