View Single Post
Old 05-21-2008, 02:18 PM   #9
sfj642
Member
 
Join Date: May 2007
Location: Minehead, Somerset, UK
Posts: 89
iTrader: (0)
Default

hi there - the instrument cluster is only held in by two Torx screws (T20 ?) at the top. It is a very close fit and there are no obvious bits to pull on and I can understand it may appear tight. But you need to get hold of it somehow to pull it forward (no need to unplug for this exercise).

After that, the two hidden screws behind the switch escutcheons can be removed and the instrument cluster surround pulled towards you. That should give you access to the two pilot lamp assemblies.

Hope this helps - be firm but careful with it !
sfj642 is offline   Reply With Quote