View Single Post
Old 03-31-2016, 10:37 PM   #104
karibuni
Junior Member
 
karibuni's Avatar
 
Join Date: May 2015
Location: NC
Posts: 29
iTrader: (0)
Default

EDIT 2: Apparently on M42 there is just the 1 O-ring and no bush (search button is your friend , so I'll try and get this on over the weekend

http://www.318ti.org/forum/showthrea...filter+housing

EDIT: On the M42 are we just replacing the 1 O-Rings? My valve looks metal and not to be removed, so do I just take the O-ring off the bushing I ordered (tricky) and replace the one that is on there?

Looks like the protrusion from my oil filter housing that comes out is just stuck on there, as I recall it has the flattened O-ring that is sympotmatic of time / wear on these units. It's stuck in there pretty good! Will have to vice grip it out and replace with the new unit. Will do the recommended lube-ing of the new bush / valve to get it to fit into the Housing. There are still droplets of oil (not as bad as before) under the car, so looks like this will be another step to relieve that
__________________

1995 318ti Base Daily Drive
212K Miles
Sensen APK Struts • Vaico Control Arms • Karlyn Tie Rods • HLC Sway Bar End Links • Strong Arm Hatch Lifts

Last edited by karibuni; 03-31-2016 at 10:53 PM.
karibuni is offline   Reply With Quote