View Single Post
Old 09-07-2010, 07:59 PM   #5
xxxJohnBoyxxx
Senior Member
 
Join Date: Dec 2007
Location: Gulfport, Florida
Posts: 3,208
iTrader: (1)
Default

You can also find a bolt that fits the pinning location and slide that in and put a nut on the back side then tighten the nut to jam that into the flywheel locking areas. This was the best way to ensure the bolt does not pop out of the flywheel locking hole while you are chanking on front nut with the breaker bar.
xxxJohnBoyxxx is offline   Reply With Quote