View Single Post
Old 09-05-2010, 04:37 PM   #1
LennyG
Junior Member
 
Join Date: Aug 2010
Location: Lexington, SC
Posts: 9
iTrader: (0)
Question Crankshaft center bolt removal

I have to get the crank bolt off of my engine. The spec is 240lb/ft and I have a feeling it is even tighter than that. I have locked it up to the frame with the breakerbar to use the starter and all I get is a snap. The starter is not strong enough to do the job. Any ideas. I have plenty of room. The engine is coming out so it is mostly disassembled.
Thanks in advance.
LennyG is offline   Reply With Quote