View Single Post
Old 11-18-2008, 05:37 PM   #6
xxxJohnBoyxxx
Senior Member
 
Join Date: Dec 2007
Location: Gulfport, Florida
Posts: 3,208
iTrader: (1)
Default

Quote:
Originally Posted by Xenocide View Post
Dude, chill out on the solder. Haha, use some flux next time and practice makes perfect!
Believe it or not I'm a expert at solding. Problem was I was not sober with very shaky hands when I did this. I normally use a air solder gun on pc boards but used a large tip trigger gun. I do hobby wiring on BGA (ball grid array) chips were there are 80 pin out's in the size of a dime, by hand. Also I had to add and remove pots, resistors, etc to get the correct resistance for the mv I needed. I couldn't use OHM's law because the O2 sensor is a voltage generator with no reading or data on watts or amps. If I did one today sober and a fresh board it would look sharp trust me. I would post some pictures of my hobby work but I don't want to expose who I am in the pirating world of smart cards.

John S
xxxJohnBoyxxx is offline   Reply With Quote