Thread
:
New rear brake upgrade solution!
View Single Post
04-22-2018, 04:03 AM
#
42
Deeznutz
Member
Join Date: Jun 2015
Location: Brooklyn
Posts: 58
iTrader: (
0
)
Photo Gallery
New rear brake upgrade solution!
So I just completed this upgrade, and I just have to say if I didn't read this thread again recently I don't know what I would have done. Do not I repeat DO NOT BUY 128I ROTORS OR Z4 CALIPERS, I learned this the hard way. What I ended up using was E46 REAR CALIPERS AND Z4 3.0 ROTORS. This combination seemed to bolt together as intended and the parking brake works. Also I had to pretty much cut the entire back half of the dust shield off as well as the entire curved portion. You have to get pretty close to the parking brake mounting point without going to far. The last issue is the brake line doesn't quite reach, I cut near the hard line mounting bracket and folded it back towards the axle for the line to reach (i know this seems hacked but my car is used as a track car mostly and I don't care to cut it up to make things work) with that said I will try to source longer braided lines or weld the hard line bracket to the swing arm itself. All and all it seems like a solid solution for a rear upgrade if done with careful planning it can be done nice and look OE.
Sent from my SM-T817T using Tapatalk
Last edited by Deeznutz; 04-22-2018 at
08:02 PM
.
Deeznutz
View Public Profile
Send a private message to Deeznutz
Find More Posts by Deeznutz