Raising this thread from dead!
my 96 318iC has ABS light on and I tested the following
1) 3 ABS fuses
2) shorted pin 30 and 87 of grey relay - pump is cycling
3) tested grey and red relay with a 9 v battery . relay latches just fine
4) tested 4 wheel sensors with an ohm meter. all look good. also tested it generates some voltage when the wheels were spun
What else should I be checking?
I was wondering where is the "slip Control module (ABS)" located from the picture Dave posted in the beginning of this thread?
Thanks for any help |