Engine Replacement, Harness Question I'm replacing the blown engine in my '97 ti. The replacement engine I sourced is from a '96 ti. I was planning on swapping in the new harness but have found that the wiring is a little different between the replacement and original harnesses. In addition to the large DME connector, the original harness as a small wire (ground??, I can't see what it's connected to) connected in the DME cavity. This extra wire is not present on the new harness and doesn't appear to have ever been there. Replacement DME is 1 432 763 Original DME is 1 429 924 So my plan now is to use the original DME and harness with the replacement motor. Should I expect any problems? TIA, Joe Last edited by joe325is; 07-04-2010 at 11:42 PM. |