318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 178
Search took 0.01 seconds.
Search: Posts Made By: Junk
Forum: Brakes 06-19-2011, 06:09 PM
Replies: 280
Views: 182,167
Posted By Junk
Larger brakes can be useful even if your stock...

Larger brakes can be useful even if your stock brakes can lockup the wheels (drum brakes can cause lockup too) but there is the time it takes to lockup and the pedal feel, perhaps an improvement in...
Forum: US and North America 06-04-2011, 03:02 PM
Replies: 14
Views: 4,226
Posted By Junk
nope

nope
Forum: US and North America 06-03-2011, 03:47 PM
Replies: 14
Views: 4,226
Posted By Junk
I believe 98-02 M coupes and roadsters. S54 has...

I believe 98-02 M coupes and roadsters. S54 has 3.15 ratio vs. 3.23 of the S52 versions.
Forum: US and North America 06-03-2011, 03:39 PM
Replies: 14
Views: 4,226
Posted By Junk
It has re-inforcement inside the subframe, so it...

It has re-inforcement inside the subframe, so it maybe stronger... and it acts as a ballast weight for the rear end :P
Forum: Differentials 05-23-2011, 04:07 PM
Replies: 2
Views: 1,209
Posted By Junk
M coupe rearend fits perfect, same width. I...

M coupe rearend fits perfect, same width. I thought I heard the standard 6 cylinder z3's have wider rear track because they use narrow, more offset wheels than the m coupe.

gearing with the 3.15...
Forum: Transmission 05-23-2011, 03:58 PM
Replies: 1
Views: 1,742
Posted By Junk
Sounds like you did gravity bleed? Might...

Sounds like you did gravity bleed?

Might still have an air bubble in there, I'd get someone to push the pedal for you, or maybe rig up a stick to hold the clutch pedal in, then climb under and...
Forum: Exterior 04-27-2011, 03:42 PM
Replies: 30
Views: 8,194
Posted By Junk
widebody can make any car look cool! After seeing...

widebody can make any car look cool! After seeing some widebody pinto's, I like ford pintos! Le-car turbo? Toyota starlet widebodies..Yes our ti's already look cool, just not in a radical way.
...
Forum: Exterior 04-10-2011, 09:03 AM
Replies: 7
Views: 1,910
Posted By Junk
I had some DS2's coated dark metallic gray...

I had some DS2's coated dark metallic gray semi-gloss and they are too glossy to me. I'm thinking satin might be the right finish..

the wheels you have, I like them stock.
Forum: Maintenance 03-28-2011, 05:01 PM
Replies: 11
Views: 2,928
Posted By Junk
exellent point as always Dave, never thought...

exellent point as always Dave, never thought about a ripped boot flapping, that sure could make things run funny.

if that's not it, and you check what John_in_VA said, center bearing, you might...
Forum: Maintenance 03-28-2011, 02:43 PM
Replies: 11
Views: 2,928
Posted By Junk
Was the old clutch pretty bad and did you...

Was the old clutch pretty bad and did you re-surface the flywheel? Maybe it needs breaking in?

If you check the center bearing, you might want to make sure it is pre-loaded. The bracket is slotted...
Forum: Engine Swaps 03-28-2011, 08:08 AM
Replies: 6
Views: 1,302
Posted By Junk
I had trouble unbolting the driveshaft/guibo so I...

I had trouble unbolting the driveshaft/guibo so I dropped the whole thing on the floor (subframe/steering rack removed already). Unbolted the tranny from the engine, dragged that out from under the...
Forum: Engine Swaps 03-28-2011, 07:52 AM
Replies: 37
Views: 6,745
Posted By Junk
'97+ ti has the canister behind the rear...

'97+ ti has the canister behind the rear passenger armrest area I think, M3 version may not fit, maybe have to put it in the trunk area somewhere. check out www.bmwfans.info for diagrams.
Forum: Engine Swaps 03-21-2011, 03:40 PM
Replies: 37
Views: 6,745
Posted By Junk
The fuel tank pressure sensor is just tee'd into...

The fuel tank pressure sensor is just tee'd into the little hose that drains overspilled fuel into your tank. The charcoal canister, you want '97+ or from another E36, the obd-ii one has a valve...
Forum: Engine Swaps 03-18-2011, 04:44 PM
Replies: 15
Views: 3,114
Posted By Junk
Thanks for the pics Bluebimma, hey you only using...

Thanks for the pics Bluebimma, hey you only using one muffler, I am guessing that's the 318 and the c57 will have dual mufflers? Too bad I'll need two cats if I stick with dual exhaust, but the...
Forum: Lounge 03-14-2011, 03:08 PM
Replies: 7
Views: 7,545
Posted By Junk
4 door porsches, fwd bmw's.. the end is coming! ...

4 door porsches, fwd bmw's.. the end is coming!

Ferrari will save us!

I can imagine they might want to develop the transverse layout since a lot of awd cars use them.. Maybe their Mini was too...
Forum: Electrical 03-14-2011, 02:59 PM
Replies: 4
Views: 1,566
Posted By Junk
I'm guessing heater control valve. Should be on...

I'm guessing heater control valve. Should be on the firewall next to your brake booster, plugs in from the bottom.

-correction plugs in from top
Forum: Engine Swaps 03-14-2011, 05:38 AM
Replies: 15
Views: 3,114
Posted By Junk
Yes being sarcastic! .. that old gas really is...

Yes being sarcastic! .. that old gas really is bad though.. engine did not want to accelerate with load. It sounded better after I mixed some fresh gas in, so I'll drain it before running it again.....
Forum: Engine Swaps 03-13-2011, 05:43 PM
Replies: 15
Views: 3,114
Posted By Junk
Thumbs up I hear you Jess, it's like those inconsiderate...

I hear you Jess, it's like those inconsiderate f*%#s that burn firewood. Selfish bastards, I mean who cares if they stay warm, they shouldn't be polluting the air.

the old gas smells espcially...
Forum: Engine Swaps 03-13-2011, 09:40 AM
Replies: 15
Views: 3,114
Posted By Junk
Side exit would be cool! I just can't imagine a...

Side exit would be cool! I just can't imagine a proper setup on the ti yet though..

How do you like the 2.5" single sound? I might change it sometime.. thinking part of the reason it sounded so...
Forum: Engine Swaps 03-12-2011, 06:50 PM
Replies: 214
Views: 48,970
Posted By Junk
Wow! I'm amazed you got it out with a load...

Wow! I'm amazed you got it out with a load leveler attached to the hoist, under the garage door! Great job!

The guy I bought my motor from told me to use the driver engine mount and back of the...
Forum: Engine Swaps 03-12-2011, 03:04 PM
Replies: 15
Views: 3,114
Posted By Junk
worst exhaust.. ever

Well it's basically a stock s52, stock midpipe with cat delete (because the midpipe section I received has signs of overheating in one of the cats)

still going to add mufflers, thought I'd see if...
Forum: Maintenance 03-11-2011, 04:54 PM
Replies: 19
Views: 4,274
Posted By Junk
I once saw a post where someone had a bad antenna...

I once saw a post where someone had a bad antenna ring and the cold weathr somehow affected it. Since you have a code for the EWS you might try jiggling he antenna ring or inspecting the wiring under...
Forum: Engine 03-04-2011, 03:08 PM
Replies: 1
Views: 972
Posted By Junk
I don't think the full synth is going to help you...

I don't think the full synth is going to help you here. Was your oil light on? I am guessing the clacking maybe the timing chain (tensioner). Should have had your friend get your oil! Noise being...
Forum: Engine Swaps 03-03-2011, 06:57 PM
Replies: 2
Views: 1,775
Posted By Junk
Trust factor? NONE! Good advice, I once...

Trust factor? NONE!

Good advice, I once drove 100 miles for a fender in the bay area, (used that very same website, insurance companies use it too I found out) They told me it was good. When I got...
Forum: Lounge 02-25-2011, 04:44 PM
Replies: 28
Views: 6,098
Posted By Junk
If you find space to mount the full size obc,...

If you find space to mount the full size obc, there is a guy planning to reprogram it to display other sensors among other things. Full on factory look, just be loosing the radio I guess..
...
Showing results 1 to 25 of 178

 
Forum Jump

All times are GMT +1. The time now is 10:06 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 71.66 k/80.36 k (10.83%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.