Forum: Electrical 04-19-2012, 04:05 PM |
Replies: 12 Views: 5,200 Reseting the OBD after oil change The smog tech is right. Once you reset your OBD, then you need at leat 150 miles to accumulate new data to satisfy the smog tester computer. This is to prevent people from just resetting their bad... |
Forum: Electrical 03-23-2011, 03:52 PM |
Replies: 12 Views: 5,200 I found the cause of my failed connection. I... I found the cause of my failed connection. I had reset the oil indicator the previous night, and forgot to twist tight the 20 pin connector lid under the hood. After tightening the cap, I was able... |
Forum: Electrical 03-18-2011, 04:24 AM |
Replies: 12 Views: 5,200 |
Forum: Lounge 12-04-2009, 08:27 PM |
Replies: 6 Views: 4,477 Don't use fork Don't waste your time using a fork. I tried in vain to separate the ball joint using a fork. Buy a ball joint separator instead. It will save you time and do less damage to the wheel spindle. ... |
Forum: Electrical 02-17-2009, 11:03 PM |
Replies: 3 Views: 1,589 |
Forum: Engine 02-17-2009, 07:29 PM |
Replies: 13 Views: 2,228 My mystery has been solved! I finally towed... My mystery has been solved! I finally towed my car to a shop and after going over all the possible causes and came up fine. The problem, as it turn out, was constipation. My catalytic converter... |
Forum: Engine 02-17-2009, 07:01 PM |
Replies: 21 Views: 6,653 My mystery has been solved! I finally towed... My mystery has been solved! I finally towed my car to a shop and after going over all the possible causes and came up fine. The problem, as it turn out, was constipation. My catalytic converter... |
Forum: Electrical 02-17-2009, 06:09 PM |
Replies: 3 Views: 1,589 Can I use DME from auto with my manual? I have a 98 sport manual with possible DME problem. I found a member with a good DME, but the part comes from a 98 auto. I searched realOEM but there are just so many part numbers for the DME... |
Forum: US and North America 02-16-2009, 03:56 AM |
Replies: 123 Views: 26,581 |
Forum: Engine 02-11-2009, 11:14 PM |
Replies: 13 Views: 2,228 |
Forum: Engine 02-11-2009, 11:12 PM |
Replies: 21 Views: 6,653 |
Forum: Engine 02-07-2009, 08:50 PM |
Replies: 21 Views: 6,653 |
Forum: US and North America 02-06-2009, 12:00 AM |
Replies: 55 Views: 10,435 |
Forum: Engine 02-05-2009, 08:39 PM |
Replies: 21 Views: 6,653 OK, I narrowed it down to a bad MAF. ... OK, I narrowed it down to a bad MAF. According to Bently manual, a bad MAF will make your DME to go into "Limp" mode. My ignition, fuel delivery, emission, all are normal. So I am buying a used... |
Forum: Engine 01-30-2009, 05:50 PM |
Replies: 21 Views: 6,653 OK, I'll give it a try. I have reset the... OK, I'll give it a try. I have reset the "cylinder 1 misfire" and I'll drive it on my neighborhood streets some more to see if anymore codes would come up. I have the Bently manual and I will... |
Forum: Engine 01-28-2009, 11:32 PM |
Replies: 21 Views: 6,653 |
Forum: Engine 01-28-2009, 08:40 PM |
Replies: 13 Views: 2,228 |
Forum: Engine 01-28-2009, 08:38 PM |
Replies: 13 Views: 2,228 |
Forum: Engine 01-28-2009, 07:36 PM |
Replies: 13 Views: 2,228 |
Forum: Engine 01-28-2009, 07:23 PM |
Replies: 21 Views: 6,653 |
Forum: Engine 01-28-2009, 07:10 PM |
Replies: 13 Views: 2,228 Disappearing power. M44 help!!! I have a very strange problem and hopefully you guys can tell me what to look for. I was driving on the freeway yesterday and all of a sudden, I lost power (50%). The engine still runs as if I was... |
Forum: US and North America 01-28-2009, 07:09 PM |
Replies: 55 Views: 10,435 |
Forum: Suspension 11-13-2008, 05:30 PM |
Replies: 22 Views: 7,172 |
Forum: Suspension 11-06-2008, 01:31 AM |
Replies: 22 Views: 7,172 |
Forum: Suspension 11-06-2008, 01:07 AM |
Replies: 22 Views: 7,172 I have the same problem when I bought the car.... I have the same problem when I bought the car. After replacing all these (in order), the steering wheel still vibrate, but a lot less now. 1. Tie rod 2. control arms with m3 solid bushings and... |