318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: btbiii
Forum: Engine 08-21-2012, 08:21 PM
Replies: 66
Views: 35,250
Posted By btbiii
Voltage was measure with fuel pump relay...

Voltage was measure with fuel pump relay unplugged by placing a volt meter across fuel pump relay coil receptacle tabs outside fuse panel. If I connect negative lead to chasis and positive to fuel...
Forum: Engine 08-11-2012, 10:48 PM
Replies: 66
Views: 35,250
Posted By btbiii
No voltage to fuel pump relay

Pierre,
Thank you for response. I can get the voltage to the fuel pump by jumping it out. My issue-EVEN with cranking there is only 5.5 volts going to fuel pump relay. I checked DME relay and it...
Forum: Electrical 08-11-2012, 09:25 PM
Replies: 0
Views: 1,297
Posted By btbiii
Low voltage to fuel pump relay

Car not starting, No voltage to fuel pump. Check fuses, replace relay-STILL NG. By-passed relay-Fuel pump came. Found I am only getting about 5.5v. to Coil of fuel pump relay. Does anyone have...
Forum: Engine 08-11-2012, 02:51 PM
Replies: 66
Views: 35,250
Posted By btbiii
96 318ti will not start-

I cannot start a 96 318ti. I did not hear fuel pump coming on, so I checked for voltage to plugs. Which one is fuel sensor and which one is for pump? I have a Yellow and a Gray? I went into fuse...
Forum: Engine 11-15-2010, 04:09 AM
Replies: 5
Views: 1,570
Posted By btbiii
Thank You

It appears to come from a T that comes off a check valve, another piece called a "container". I guess it fell off and some one got creative. When I took the intake manifold off, I found out that...
Forum: Engine 11-15-2010, 12:17 AM
Replies: 5
Views: 1,570
Posted By btbiii
Pictures

I added the line I found, and the throttle body. If you look at the throttle body it has a short piece of hose on a barb, but it is choked off with an L piece of round stock, like a round allen...
Forum: Engine 11-14-2010, 06:46 PM
Replies: 5
Views: 1,570
Posted By btbiii
Vacuum line-where does it go?

I just re-assembled by intake manifold after replacing all of my coolant lines and plastic connectors. I have small diameter vacuum line that I cannot find the home for. It is connected to a tee...
Forum: Knowledge Base 08-29-2010, 07:42 PM
Replies: 31
Views: 62,207
Posted By btbiii
Bleeder for cooling system

Where is the bleeder for the cooling system? Is it the screw next to radiator cap? Do I just remove the plastic plug?
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT +1. The time now is 06:59 AM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 40.98 k/47.38 k (13.50%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.