Re-set brake pad wear indicator light I just replaced all my brake pads with EBC greenstuff jobbies & fitted new wear sensors. I assumed that the wear indicator idiot light would go out when the new sensors were plugged in but I can tell you it doesn't. Great I'm thinking, bloody BMW have frigged it so that you have to get a dealer/tool to re-set the light to discourage home servicing. Anyway, after a bit of searching I found the solution & there's nothing to it. Just turn the ignition to on so the gauge cluster all lights up & leave it there without starting the car. After about 40 seconds the light goes out & your done :smile: |
Cool tip! it may be a good idea to open a KB article for others... |
I was told to hold the brake pedal down for ten seconds then start your car. I started her up and it was on so I did the above that and it worked,that was the only method i tried. |
All times are GMT +1. The time now is 08:54 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org