Drive shaft questions??? As you know im doing an M50 swap. I have the choice of using either the stock M44 tranny or the M50 tranny. (both getrag) If I use the M44 box, I still use my stock shaft right? And if I use the M50 box (preffered) Do I need the front section of the shaft from a 325 or can I still use my stock shaft? I have both gearboxes but only my stock shaft at the moment. Ive searched the forum but can't find a definate answer. Cheers |
I don't know the differences between the getrag units, but im pretty certain you will want to use the shaft from whatever drivetrain you use .... m50 tranny - use m50 shaft, m44 tranny - use m44 shaft. I know my m44 shafts works perfect with my 2.8 and stock box |
Did you have to move the gearbox back onto the second set of mounting holes or just leave it where is was with the 4 cyl in? Also which clutch and flywheel are you using? 318 or 328? |
leave it where it is i do believe |
Quote:
|
All times are GMT +1. The time now is 09:27 PM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org