My TI track tool build Hello all! I am new here and would like to share my 318TI track tool project that I am working on here in Norway:smile: The car is a 1998 318TI that i bought for cheap back in 2017. It had a M42 swap because the previous engine blew up somehow. https://i.imgur.com/nqwRpTv.jpg https://i.imgur.com/WluJtP5.jpg https://i.imgur.com/z58YmdN.jpg It was in really bad shape, but i threw some brakes, coilovers, bucket seats and steering wheel in it and did a full season of trackdays without any issues. https://i.imgur.com/maCLuMy.jpg https://i.imgur.com/kpLqsgC.jpg However during the autumn i moneyshifted the car and bent some valves (engine still running like a champ). I decided to use the winter to rebuild the engine. https://i.imgur.com/iemI16V.jpg https://i.imgur.com/6Qlw7t3.jpg https://i.imgur.com/qDIS2ge.jpg https://i.imgur.com/f6au5RE.jpg https://i.imgur.com/eFfKNA2.jpg https://i.imgur.com/gYrcBg0.jpg https://i.imgur.com/84zklJQ.jpg |
Cylinder head was toast, so I bought a refurbished one from ebay. https://i.imgur.com/GAACRFj.jpg https://i.imgur.com/TT1jIKo.jpg https://i.imgur.com/3TTyHEl.jpg https://i.imgur.com/dAcI46h.jpg https://i.imgur.com/HJ4LpGQ.jpg https://i.imgur.com/wMPqzGQ.jpg https://i.imgur.com/qDzx57F.jpg https://i.imgur.com/5kautkd.jpg https://i.imgur.com/meKeOkV.jpg Basic overview of what was done to the engine: -Painted block and covers -Honed cylinder walls -Refurbished cylinder head -New piston rings and rod bearings -Replaced all gaskets and seals -New temp sensors in cyl. head -New knock sensors -New water pipe -New waterpump and thermostat -New ICV valve -New CCV -New startermotor -New alternator -New coil pack and wires -All filters and spark plugs -New clutch -Rebuilt shifter linkage As far as mods go, this is the current state of the car: Drivetrain: Catback exhaust Some ebay chip with raised limiter 7000rpm 4.10 diff from E30 M40 single mass flywheel E36 M3 shift lever w/ZHP knob Suspension: JOM coilovers Powerflex rear control arm bushes Powerflex diff bushing Brakes: Brakemotive drilled/slotted discs Mintex racing M1155 pads front Mintex racing M1144 pads rear E36 M3 master cylinder Wheels/tires: 17" Style 44 wheels Toyo R888 semislicks Interior: OMP steering wheel Sparco Sprint bucketseats |
All times are GMT +1. The time now is 12:25 PM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org