no injector pulse, **PLease Help** Im trying to get my car running. There is no pulse at the injectors, It just show 6v when i turn the key on. I have spark, fuel in the rail and pump is working. What could cause it to have no pulse. Could it be crank angle sensor or ecu? Thanks, Tyler |
Tyler, we need more information on your car than that... for all I know your talking about a Toyota Tercel. Need year of your car, why doesn't it run (other than the no injector pulse), what you replaced to try and fix it, etc etc etc etc.... |
It's a 1998 318ti, haven't replaced anything yet. If I had a tercel I wouldn't try it fix it. |
Tyler, start with checking power relay you should have battrey voltage at your injectors |
There is power at the injectors. The car was in a rollover before it was parked, could that have anything to do with it, or should rule that out? |
tyler, you said you only had 6 volts NOT ENOUGH you need 12volts |
If you need new injectors let me know. I MIGHT still have a set left. |
anyone? help |
You said you have 6volts at the injectors. Is that 6volts to chassis ground or 6 volts on the plug? Please check voltage to chassis ground. After identifing the ground on the injector plug do a continuity from plug ground to chassis ground. Are all injectors reporting the same voltagesand gorunds? This will eliminate wiring issues. Please do this then we will move on to the DME tests |
(This tests on the two wire pug to the injector) One wire grounded to the chassis reads 12V and the other wire grounded to the chassis has 6V. I had the volt meter across both of the wires and got 6v (+12v-(+6v)=6v). So both of the wires are positive. One of the wires is supposed to be grounded to the ecu, right? |
You should have a red/white going to each injector which is 12 volts. Then you should have Brown/(wht ~ 4, blu ~ 3, grn ~ 2, yel ~ 1) for each injector where the Brown/white is Cylinder #4 and on down with each color I listed. The injector works with 12volts constant and the DME grounds it to fire a pulse. When you checked voltage for me you verifed we have 12volts at red/white so that is good. You should not get an accurate reading from any injector plug terminal since it is 12volts positive and a open circuit to the DME. That circuit (or Brown/(color for cylinder)) would be grounded only if the DME was firing the injector, if it was firing an injector you would see 12volts for a micro second. Check an injector for resistance to ensure the coil is not burned out |
I don't want to sound like a smart ass but how do you know the injector are not pulsing? |
What happened? Is it working now??? |
No, its still not working. Think the dme is dead |
Quote:
You have fuel pressure and spark right? If you want to send me your DMW EWS and a Key and will check it all for free and fix any issues I can. If it is in fact a injector driver issue I can fix that or sell you a complete DME, EWS and Key and explain how to use your original key and still have EWS with a hidden key ring antenna and key for the new DME. Easy to explain over the phone. CoolJess would have the parts from his swap and it's much cheeper then a $1000+ dealer fix... Where do you live? |
All times are GMT +1. The time now is 01:14 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org