m54 swap questions Ok guys, as you can see by my join date I have been around a while (albeit very dormant after selling my 97). I was going to swap my 97 ti to an m54, but I never got around to doing it. A few years has gone by and I still have the itch (and some very expensive metal sitting around) to do it. So here it goes: 1) The M54 I have is out of an '01 Z3 automatic, so I will probably need to acquire a 5spd harness, correct? 2) I was wondering if I can run an M50 intake on the M54? (because the flapper valve on the intake was damaged when my motor was shipped to me) 3) Can I use M3 or 328 exhaust manifolds? (the z3 manifolds have cats and were cut) I have done many other engine swaps into various cars from old VW Sciroccos, to Hondas, a Nissan, and my latest is a VR6 powered VW Cabrio (freaks people out when you drive a "chick car" that growls with 12v and 2.8L of V6 power!). So I am not scared to get my hands dirty again, I just want to figure out the best means of engine management and getting air in and out of the car! THANKS IN ADVANCE, I truly look forward to being back here on the boards! ~Matt:biggrin: |
im truely excited to see this build!! it will have many pictures.....RIGHT???? :) subscribed |
Hope you accomplished your goal |
All times are GMT +1. The time now is 06:01 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org