318ti.org forum (http://www.318ti.org/forum/index.php)
-   Engine Swaps (http://www.318ti.org/forum/forumdisplay.php?f=26)
-   -   M52 swap No Crank (http://www.318ti.org/forum/showthread.php?t=45296)

Filiski120 01-04-2024 09:10 AM

M52 swap No Crank
 
Hey yall,
Just finish a m52b28 swap into my ti, but there is no crank.
Fuel pump will prime but starter won’t do anything.
Donor car was a 1998 328i sedan auto.
My ti is a 1996 318ti manual
Starter is also brand new so that’s not the problem.
I swapped all the ews stuff from the 328i into the ti. So the dme, ews2 module and the key transponder.
I’ve also tried jumping the green and yellow wires on the ews module and still nothin.
I’ve gone through and checked all the connections and grounds multiple times as well and everything is hooked up.
Need y’all’s help or advice.

Filiski120 01-04-2024 07:36 PM

So today I tried jumping pins 1 and 3 again… and it started!!! The sound of the open headers was beautiful to hear. Now after reading I think the issue is the key is not aligned with the ews module. I swapped the key transponder from the 328i into my 318ti key. But I guess that didn’t work. So how do I go about aligning the key to the ews module?

J!m 01-10-2024 04:35 PM

Maybe the alignment; what did you do to accommodate the neutral safety switch?

A dealer, or some aftermarket software will allow EWS alignment. At this point you may consider a hard-bypass on EWS too.

But the first question still stands- an automatic DME is looking for inputs from the transmission it will not get from a manual... the DMEs are different...

It is starting and running, which is great, but driveability may be poor...

Filiski120 01-10-2024 05:25 PM

Hi Jim,
Thanks for the reply. But since my ti is a manual it doesn’t have a neutral safety switch. For the ews I think I am just going to leave it jumped cause it starts and runs like that. For the dmes I thought they were the same but once you plug an auto trans computer into it, it puts codes into the dme. It also runs fine at idle but when I went to drive it, it would stall out when you try and decelerate.

Andy318 03-01-2024 11:06 PM

Hi, don't want to thread jack so I started a new thread for my M50 swap no start. In my case the car was an automatic and converted to manual but the car was starting, running and driving for a long time before my current no start issue...

Do I need to recheck anything related to the missing automatic trans again? And if so what am I looking for?

Btw, I bought the car from someone who used it after buying it from the swapper!


All times are GMT +1. The time now is 07:09 AM.

vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org